Manfred Weber
Metra Mess- und Frequenztechnik in Radebeul e.K.
Since 1954

Software Download

VibroMetra PC Vibration Measuring System


VibroMetra Software (ca. 6 MB)
This software is fully operational after registration. It can be tested without registration in Trainer mode with simulated sensor signals (see instruction manual).
Device driver M302 for 32 and 64 bit Windows, ZIP 60 kB
Device driver M312 for 32 and 64 bit Windows, ZIP 60 kB
Device drivers for VM-RADIO and VM-ADAM (ZIP 300 kB)
Firmware update version 2.0.390 for M312

8 Channel IEPE Conditioner M208A

M208A Control Center (4 MB) - M208A operating and measuring software for Windows PCs
Firmware Updater (400 kB) - Utility program for firmware update
M208A Firmware - Ver. 001.006 current M208A firmware file, please save the hex file and install it with Firmware Updater.
Notice: Press the "<" key of your M208A to check the firmware version installed on your instrument.

Human Vibration Meter VM30-H

vm30_english.XLS - Ver. 2 Excel file with macro for data import from VM30-H into Excel, English version
vm30.dll - required for data import from VM30-H into Excel. Please copy to Windows system folder.

Vibration Meter for Wind Energy Plants VM30-W

vm30-w_english.XLS - Excel file with macro for data import from VM30-W into Excel, English version
vm30.dll - required for data import from VM30-W into Excel. Please copy to Windows system folder.

Vibration Calibrating Systems VC100 and VC110

PC-Software for Vibration Calibrating System VC100 (former model) (approx. 2 MB)
PC-Software for Vibration Calibrating System VC110, Ver. 2.1 (approx. 2 MB)

TEDS Support

Manufacturer Model Enumeration File  This standard file includes the reference between the model numbers stored in the TEDS memory and Metra's actual model numbers.
TEDS-IO Ver. 1.2 Windows program for reading and editing the information stored in the TEDS memory (approx. 5 MB)
Notice:  This program requires for operation a connected  1-Wire® adapter with installed driver. Maxim offers USB and COM port adapters. For further information please contact http://www.maxim-ic.com/products/ibutton/software/tmex/
After driver installation please run "Default 1-Wire Net.exe" and perform automatic hardware detection. Once your adapter was detected it will remain stored as standard device for the communication between TEDS-IO and the sensor.
For connecting a sensor to the
1-Wire® adapter you will need an interface cable. Please contact us if you need support.